Solar Store
EnergyRefuge.com

EnergyRefuge.com
Solar Store
Alternative Energy Blog
Energy News
Energy How-To's


HQRP Solar 10A Charge Power Controller / Regulator 12V / 24V 10 Amp with Digital LED Display plus HQRP Mousepad

HQRP Solar 10A Charge Power Controller / Regulator 12V / 24V 10 Amp with Digital LED Display plus HQRP Mousepad

Other Views:
Brand: HQRP
Category: Home Improvement

Buy New: $31.91
as of 11/21/2009 00:11 CST details



Seller: Osprey-Talon
Rating: 4.5 out of 5 stars 3 reviews
Sales Rank: 14127

Media: Misc.

MPN: 88466710707095
UPC: 884667146017
EAN: 0884667146017
ASIN: B002GJ456S

Availability: Usually ships in 1-2 business days

Tell A Friend
Add to Wishlist
Add to Wedding Registry
Add to Baby Registry

Features:
  • HQRP® Solar Charge Controller plus HQRP® Mousepad;
  • Equalisationvoltage: 14.8 Volt; High voltage disconnect: 14.4;
  • Float voltage: 13.6Volt; Low voltage disconnect: 11.1 Volt;
  • Low voltage reconnect: 12.6 Volt; Self-consumption: 6mA maximum;
  • Terminals: for wire sizes to 6mm2; PWM charge mode & state of charge (SOC).

Editorial Reviews:

Product Description
Products trademarked HQRP® are marketed and sold exclusively by Osprey-Talon. HQRP Solar Charge Controllers are high quality, efficient and reliable Solar Power Regulators. They are perfect for rural electrification system. They offer a lot of possibilities and benefits. Regulations point: 14.4 Volts; Low voltage Disconnect: 11.1V Volts; Low voltage Reconnect: 13.1 Volts; Microcontroller digital accuracy; Type of Charging: Series PWM & stat of charge(SOC); 4 Stages: equalization, PWM, Boost and Float, temperature compensated charging; Electronic protections: Short circuit and over current-solar and load; Reverse polarity-solar, load, battery; Reverse current at night; Limits high voltage to protect loads; Lighting protection; Tropicalization Conformal coated printed circuit board; Terminals For wire sizes to 6mm2; Self-consumption: 6mA maximum.


Customer Reviews:
5 out of 5 stars Good PWM charger for the cost   October 23, 2009
Edward Youmans (OKC, OK)
2 out of 2 found this review helpful

I'm satisfied with this PWM PV charge controller. Compared to other charge controllers and even those of PWM or MPPT, this one has the best cost. Only around $30 compared to those that do the same and cost around in the $100's. With PWM techonlogy, the charger is neither on or off like some of the cheaper controllers. Instead it regulates the voltage so it is constantly chargeing and then float chargers when the batteries are full. Also, because the voltage is being regulated closer to the batteries voltage. The batteries do not gas as much. A second thing with PWM controller, the batteries receive pulses of a charge, similar to a battery desulfator. So the batteries plates will not sulfate as much either. I found the charger regualtes the voltage .5V higher than the batteries readings. And float regulate around 13.3V. Controller can handle up to 10Amps (150Watts of PV power) and can control discharge through the controler at 10Amps. Which makes it good for outdoor ligthing or ponds where if the batteries become too low, the controller will automatically shut them down until the batteries are fully recharged.


5 out of 5 stars Great unit for solar lighting, pumps, fountains and more   September 27, 2009
instar
2 out of 2 found this review helpful

Here's why this thing rocks:
- good screw terminal connections
- connections for the solar panel, a battery, AND (this is key) a device you want to hook up TO the solar/battery system.
This last point is awesome - it provides a no-brainer way to hook up a device to a regulated / protected solar /battery system, and allows you to use the battery for power when the sun goes down or during cloudy periods - in fact, the system automatically delivers power from the battery as needed.
- Also critical is a Low Voltage Disconnect - for a solar fountain project, I first used another product without the LVD - my battery was drained completely overnight, and batteries discharged 100% can't be recharged easily (they register as an open circuit or cause other problems). This unit takes away that worry.
- The unit has a switch on it so you can turn on/off the device you're powering right from the unit.

The unit seems to be designed for rural electrification (i.e. remote villages in india needing electric lights at night). It has a conformal coating on the circuit board (anti-rust).

For me, I combined a 500 gph Rule bilge pump, this unit, a 30 watt 12 volt solar panel, and a cheap $35 12 volt tractor battery and I have an AWESOME solar fountain. I'm pretty psyched on this device, and just ordered 2 more.



4 out of 5 stars HQRP Solar 10A Charge Power Controller / Regulator 12V / 24V 10 Amp with Digital   September 18, 2009
Jesse Burton (Kentucky USA)
I thought I had bought the right product for the job I had for wt to do and when I hooked it up and it is doing what it is suppose to do and I am well pleased with yhis product and Amazon.com price

EnergyRefuge.com Solar Store
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED ‘AS IS’ AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Copyright © EnergyRefuge.com 2006. All rights reserved.

Information about prices, products, services and merchants is provided by third parties and is for informational purposes only. EnergyRefuge.com does not represent or warrant the accuracy or reliability of the information, and will not be liable for any errors, omissions, or delays in this information or any losses, injuries, or damages arising from its display or use.